The wheat planter is an ideal dry farming machine. It can complete multiple processes such as ridge shaping, side deep fertilization, film spreading on the ridge, and film side sowing at one time. It has the advantages of heat preservation, water saving, fertilizer saving, seed saving, and yield increase. , The effect of increasing income. The following specifically introduces how to eliminate common faults of the wheat planter.

Individual seed metering device does not work

The planter manufacturer explained that the reason is that the seed rack or the mouth of the seed metering device in the individual seeding box of the wheat planter is blocked by debris, and clean seeds should be replaced; the seeding shaft of the wheat planter of the planter manufacturer and the individual seeding groove wheel If the connecting pin of the wheat planter is broken, the pin should be replaced; the plug board of the individual seeding box of the wheat planter has not been opened, and the plug board should be pulled out.

Seeds are metered by the seed metering device, but there are no seeds in individual seed furrows

Planter manufacturers indicate that the opener or seed tube of the wheat planter is blocked (mostly on the opener of the ground wheel), the blockage should be cleared, and corresponding measures should be taken to prevent debris from falling into the opener of the wheat planter.

Seeding non-stop, out of control

The planter manufacturer's instructions indicate that the separation pin of the clutch brace of the wheat planter has fallen off or the separation gap is too small, and the pin should be reinstalled and locked, or the separation gap should be adjusted.

Intermittent seeding, uneven seeding

The planter manufacturer prompts that the meshing gap of the transmission gear of the wheat planter is too large, and the gear is slipping, so it should be adjusted; the elastic force of the clutch spring is too weak, and the gear is slipping. The wheat planter should be adjusted or the spring should be replaced.